MODEL 13000 Application Guide
2
Figure 2: NI-700 — Model 130SMA Master Transceiver
PB1— SERIAL LOOP BACK TEST
A valid 8870 thermostat command is sent over the
RS485 interface. A valid return data string is
expected. Green LED (D5) flash indicates a pass.
Red LED (D4) indicates a failure.
Note that the Master Transceiver position is not
interfaced with an 8870 thermostat and will therefore
indicate a loop back test failure.
PB2 — LINK
Pressing PB2 when an RCN is in the Installation
Ready mode will link that RCN to the Master
Transceiver.
PB3 — CONFIGURATION SETUP
Holding PB3 down for 3-seconds places unit into
configuration setup (see Configuration Setup section
for instructions).
PB1
PB3
PB2
D1
D2
D3
D5
D4
RED ( + )
BLK ( - )
J2
Power Supply
Network
Processor
ANT
NI-700
12VDC PWR
Crystal
Serial Interface
NI-700
9-Pin Serial Port
ANTENNA
P/N: ANT-916-MHW-RPS
RF
XCVR
RF Section