Microwave Sensor
Sensor intelligent technology
Welcome to use ES-M09B Microwave Sensor!
The product is a new saving-energy switch; it adopts
microwave sensor mould with
high-frequency electro-magnetic
wave (5.8GHz), integrated circuit. It gathers automatism,
convenience, safety, saving-energy and practicality functions.
The wide detection field is consisting of detectors. It works by
receiving human motion. When one enters the detection field, it can start the load at once and
identify automatically day and night. Its installation is very convenient and its using is very wide.
Detection is possible through doors, panes of glass or thin walls.
SPECIFICATION:
Power Sourcing: 220V/AC-240V/AC Detection Range: 360° Ceiling / 180
°
Wall
Power Frequency: 50/60Hz Detection Distance: 2-10m (radius) adjustable
Ambient Light: 5LUX/30LUX/100LUX/300LUX/DAY 24H(Adjustable)
HF System: 5.8GHz CW radar, ISM band
Time-Delay: 10sec/60sec/5min/12min/30mi
（
adjustable
）
Transmission Power: <10mW Installing Height: 1.5m~3.5m
Rated Load: 1200W (incandescent lamp) Power Consumption: 0.9W
300W (energy-saving lamp) Detection Motion Speed: 0.6~1.5m/s
FUNCTION:
Can identify day and night: It can work in the daytime and at night when it is adjusted on the
“DAY 24H” position(max). It can work in the ambient light less than 5LUX when it is adjusted
on the “5LUX” position (min). As for the adjustment pattern, please refer to the testing
pattern.
SENS adjustable: It can be adjusted according to using location; low sensitivity with only 2m
(radius) for detection distance; High sensitivity could up to 10m (radius), it fits for large room.
Time-Delay is added continually: When it receives the second induction signals after the first
induction, it will compute time once more on the basic of the first time-delay rest.
Time–Delay is adjustable. It can be set according to the consumer’s desire. The minimum
time is 10sec±3sec. The maximum is 30min±1min.
NOTE: the high-frequency output of this
sensor is <10Mw- that is just one 100
th
of the
transmission power of a mobile phone or the
output of a microwave oven.
INSTALLATIION:
(see the diagram)
Switch off the power.
Fix the bottom on the selected position with the inflated screw through the screw holes at
the side of the sensor.
Connecting the power and the load to sensor as per the connection-wire sketch diagram.
