6/6
Installing the
RF modem
Note
This section is meant to be purely informative; the RF modem and
antenna may only be installed and repaired by EnergyICT
®
personnel.
Proceed as follows to install the RF modem on the WebRTU
®
Z2 main
board:
1
Switch off the device and make sure it is no longer powered.
2
Loosen the protective panel screws.
3
Remove the protective panel.
4
Insert the RF modem, making sure that all pins of the card fit exactly in
the designated pin connections. If any resistance is felt, or if the card
was not correctly inserted, gently remove the card and insert again.
Always make sure the pins are never damaged.
5
Install the antenna. The RF antenna is packed together with the
WebRTU
®
Z2.
-
Remove the antenna from the package.
-
Screw the antenna to the copper fitting on the WebRTU
®
Z2.
-
Make sure to check the reception before fixing the antenna.
Note
Antenna’s are fixed to the RF module and are not exchangeable. They
are installed by EnergyICT
®
at production time and may not be installed
or removed by the customer. For all installations and repairs to the RF
antenna, please send your WebRTU
®
Z2 to EnergyICT
®
.
6
Replace the protective panel.
7
Fasten the screws.
