ENERGY SISTEM T3300, User Manual

Page: 19 / 20

36
37
9. SpeCIfICaTIONS
Item Specification
Tuner
Frequency Range VHF: 174MHz to 230MHz
UHF: 470MHz to 862MHz
Input Impedance 75 Ohms unbalanced
Signal Input Level -78 ~ -25 dBm
Bandwidth 7 / 8 MHz
Demodulation
Demodulator COFDM
OFDM Modulation 2K, 8K FFT, SFN and MFN
Packet Carries 2K / 8K
Guard Interval 1/4, 1/8, 1/16, 1/32
Connectors
RF IN IEC 169-2 female connector
TV SCART Composite video (CVBS), RGB, audio L/R
USB JACK For file playback or software upgrade. Also
for recording DVB-T channels in MPEG-2.
Power
Input 100-240V ~
50/60Hz
Consumption 8W max / Standby < 1W.
Display
TV mode PAL, NTSC
Resolution 720x576 (PAL); 720x480 (NTSC)
Aspect Ratio 4:3 (Letterbox, Pan &Scan), 16:9
Decoding
Video MPEG2 Transport MP@ML
Audio MPEG2 Audio Layer I&II
Others
Compliance ETSI EN 300 744 DVB-T Compliance
Sound Mode Right, Left, Stereo
Multimedia files
playback (in FAT/FAT32
format) Video (DivX, Xvid, AVI, MPG), music (MP3, WMA) and photos (JPEG, BMP,
GIF).
Problem Possible cause What to do
Standby LED not lit Mains lead unplugged Check mains lead
No signal found
Aerial is disconnected Check aerial lead
Aerial is damaged/misaligned Check aerial
Out of digital signal area Check with dealer
No picture or sound
SCART not connected Check the SCART cable connexion
Tuned to digital teletext channel Change to another channel
Mosaic blocks in picture or
picture freezes
Aerial may not be compatible Check aerial
Scrambled channel message Channel is scrambled Select an alternative channel
Forgotten channel lock code Re-install channels to cancel channel
lock
No response to remote control
Receiver off Plug in and turn on receiver
Remote control batteries are
inserted incorrectly
Check batteries direction
Front panel obstructed Check for obstructions
Remote control batteries
exhausted
Replace remote control batteries
After moving the device to
another room can’t receive the
digital signal
The aerial feed may come through
a distribution system which may
reduce the digital signal
Try a direct feed from antenna
With my device I can see
properly most of the channels,
but there are some specific
channels that I can not tune
You are trying to tune a channel
broadcasting in high definition
(HD)
Your T3300 has a built in TV channels
tuner that displays only the SD channels.
When trying to tune a channel in HD,
the screen will display only the channel
information on a black background. In
some cases, you can also hear the audio.
Change to another channel.
You are trying to tune to a
scrambled channel
The channel is only available to
subscribers. A scrambled channel
requires a decoder to be viewed with
prior authorization and payment. Change
to another channel.