Installation & Operating Manual
4
2
PRE-INSTALLATION CHECKLIST
Voltage and Polarity Check
Ensure that the operating voltage of the device is same as that of the UPS that you
have ordered. To check operating voltage of the device please check the voltage rating
given at the back of device or check the output voltage rating of original adaptor
provided by the device manufacturer.
Please refer to picture above. Make sure that your adapter voltage matches the UPS
that you have ordered. If Voltage ratings do not match, DO NOT proceed with the
installation and
Also make sure that the polarity indicator shows the center pin is positive (+). Most
adapters have this set up in very rare cases the center is negative. In that case do not
use the UPS and
Based on the configuration you ordered, follow the instructions in following sections. In
case of any questions, please
Total Current Check (for dual device only)
If you are using miniUPS in dual device configuration, please check that the sum of
currents of both the devices should not be more than the rated current of miniUPS.
Current ratings of miniUPS is 2.5A or 3.5A. All the UPS rating (2.5A or 3.5A) is specified
at 12V. If you are not sure of you set up and the model that will work for you, please
Validate Adapter Power
Connect the adaptor to power and make sure the indicator light of adaptor turns on. If
you are using your existing adaptor, make sure it is 12V. In some
models/configurations, the adaptor is provided by us.
