EnergoStrip EE24 and EE36, 230V~ / 400V3N~ are
intended for permanent installation by an authorized
electrician and in accordance with existing national
regulations. The appliance must be preceded by an
all-pole switch, min. 3mm contact gap.
Appliance and protection class: Class I - IP44.
1
. The EnergoStrip can be mounted to the ceiling
or on the wall, horizontally, where the lowest
installation height is 1.8m (2.3m UK) from the floor
level. Respect and follow the minimum distances
to the surrounding surfaces, according to fig.1. If
the heater is fitted in vertical position the connec-
tion box must be positioned at the lower end of a
sloping ceiling. Fixed heater must not be mounted
in front of a socket outlet.
2
. The two supplied ceiling brackets should be fitted
with a C/C distance, see fig.2 and table. There are
two mounting holes per ceiling bracket, where “D”
is the distance between the holes, fig.3. The fixing
brackets “FB”, on top of the heater, is to be hung up
and fixed to the ceiling brackets.
3
. We recommend fitting on to the ceiling or similar,
on supplied ceiling brackets, due to the width. If
the heater must be suspended with chains or wire
4
. On top of the heater there are two cable grom-
mets “CG”, fig.2, allowing multiple connections.
Connection according to fig.4a, 4b or 4c to a 16mm²
terminal block. When using connection 4b, one
heating element at a time can be connected (for
three output steps). Protect the supply cable, if it
comes in contact with hot parts!
5
. When starting-up the heater for the first time or
after a long period of disuse, smoke or odor may
result from grease, dust or dirt that has collected on
the element. This is normal and disappears after a
short period of time. Ensure that the room/space is
well ventilated during this process.
6
. Like in all electrical heating appliances, clicks
can occur during expansion and contraction of the
material, due to movement when the temperature
changes.
7
. The heater may undergo a color variation
(bronzing effect) following being energized for the
first time and during its life span. The extent is
relevant to the operating environment and is normal
behavior.
Aerosols, paint, solvents, dust and filth etc... may
adhere to the heater and can potentially cause
discoloration. The performance of the heater is
unaffected by discoloration or bronzing. As a pre-
caution, always switch off the heater while painting
and drying!
8
. If refit is needed, the heating elements and/or the
alu-panels can be replaced in site without having to
take down the heater. Unscrew lid and wires. Pull
or push the part in question and replace with a new
one.
9
. Information about energy consumption
In combination with an Ecodesign-compliant
thermostat, the product data complies with the EU
regulations on the Ecodesign Directive (2009/125/
EC) for energy-related products (ErP).
10
. Safety
• When the installation is protected by an RCD, a
300mA residual current device has to be used.
• Warning - Hot surface! Do not touch the heater
when in use!
• Do not cover the heater! Risk of fire!
• This appliance shall not be used by children
less than 8 years or persons with reduced
physical, sensorial or mental disability or lack
of experience and knowledge, unless they are
supervised or were instructed how to use the
appliance in a safe way, and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervi-
sion.
ENGLISH
ErP
✔