4
www.energeticlighting.com
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
2. Disconnect the photocell wire connector and set aside
the lens front cover (A).
Fig. 2
5
3. Remove the three (3) screws in front of the reflector
(B) and set the screws and reflector aside.
Fig. 3
5. Hold up the fixture back plate (C) to the junction box
(not provided) and determine which set of slots line
up with the mounting screw pattern provided by the
junction box. For proper wet location install, ensure
that silicone gasket (D) is installed between back
plate (C) and mounting surface.
Ensure that power is shut off and
connect the supply
wires to the fixture wires -- black to black, white to
white, and green to copper/bare.
WARNING:
If there is no ground supply wire, stop
installation and consult a qualified electrician.
Once wire connections are made, secure each with a
wire nut (AA).
Fig. 5
6. Secure the fixture to the junction box using the
necessary junction box screws (BB) provided to
ensure proper mounting and seal around the junction
box.
Fig. 6
7. Retrieve reflector (B) and the thre screws previously
removed in step #3, and re-install the reflector (B)
onto the back plate (C).
Optional:
Select the desired correlated color
temperature (CCT) as well as wattage using the slide
switches on the center driver housing as shown.
Fig. 7
B
C
4. For proper installation in a wet location environment,
peel off each of the adhesive protective layers from
the silicone gasket (D) and line up the slot pattern to
the back plate (C) to create a seal when installed onto
the junction box in the next step.
Fig. 4
C
AA
C
C
BB
C
B
D
D
Peel off adhesive
cover layers
D
CCT select
switch
Wattage
select
switch
