4
www.energeticlighting.com
www.energeticlighting.com
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
1
2
2. Swing open the lens front cover (A) and disconnect
the connector between the lens front cover (A) and
the back plate (B).
Fig. 2
4. Turn out the through hole plug at the center of the
junction box mating face by using a flat head
screwdriver (not included).
Fig. 4
6.
Ensure that power is shut off and
connect the supply
wires to the fixture wires -- black to black, white to
white, and green to copper/bare.
WARNING:
If there is no ground supply wire, stop
installation and consult a qualified electrician.
Once wire connections are made, secure each with a
wire nut (AA).
Fig. 6
AA
3. Swing the lens front cover (A) open and slide the lens
cover off the two hinges in the direction as shown, set
aside the lens cover.
Fig. 3
5
7. Replace the lens front cover (A) by lining up the
hinges, and reconnect the connectors between the
lens front cover (A) and the back plate (B).
Fig. 7
A
A
B
B
B
5. Prior to mounting the back plate to the mounting
surface, apply silicon sealant (not provided) around
the perimeter of the junction box to seal out water
from entering the wiring compartment. Feed the
supply lines from the junction box to the other side of
the back plate (B). Line up the junction box mounting
holes on the back plate (B) to the threaded holes on
the junction box and secure the plate to the wall with
the four junction box screws.
Fig. 5
B
Seal with
silicone
sealant
