FR
IE
Getting
started...
11
Getting started...
ENB539TAS by Energer
Before you start
> Turn the bevel locking screw (8) and set the saw blade to 0° and lock the bevel
locking screw (8).
> Unscrew the fixing screws (19) and remove bottom guard (6).
> Undo the nut (20) with a C wrench (17) on the nut itself and a spanner (18)
on the saw shaft to apply counter-pressure.
> Place one new blade (15)] on arbor shaft. Make sure saw blade teeth point down at
the front side of saw table. Place outer flange and arbor nut on arbor shaft and verify
that large, flat surface of the outer flange faces the saw blade and the saw blade (15)
is firmly seated aganist the inner flange. The bottom guard Must be re-assembled on.
Assembling the saw blade(Fig. 1-2)
Caution! Pull out the power plug.
Caution! Turn the nut in the direction of rotation of the saw
blade (15).
Caution! Note the direction of rotation (see arrow on the
saw blade).
Fig. 1
20
Loosen
Tighten
17
15
18
19
6
Fig.2
GB
IE
