4
Safety Instructions
-
To protect the floor or carpet from damage, place a mat under the treadmill.
-
Turn off the power whilst the treadmill is not in use and remove the safety key.
-
In case of emergency please place both feet at the same time on the side reins.
-
To activate an emergency stop, please detach the safety key from the console.
-
Ensure that an area of 2000 x 1000 mm behind the treadmill is free from any obstacles.
-
This product is made for home use only and tested up to a maximum body weight of 150 kilograms.
-
We take no responsibility for personal injury or damage sustained by or through the use of this
treadmill.
-
The noise creation of treadmill is under 70 db.
-
The unit requires a power supply of 220V – 240V, 50/60 HZ.
-
The function of the immobilization method: the purpose of immobilizing the treadmill is to prevent
unauthorized use. This can be accomplished by removing the Safety Key from the console,
unclipping it from the cord and putting it in a non-accessible place.
-
The emergency dismount: Follow the steps listed below if you experience pain, feel faint or need to
stop your treadmill in an emergency situation:
1.) Grip handrails for support.
2.) Step onto the lateral platform.
3.) Pull the Safety key off the console.
-
The function of the emergency stop: The Safety Key functions as the emergency stop. In an
emergency situation, remove the Safety Key from the console and the treadmill will come to a stop.
Please always put the safety key to ON position and use the power switch to turn the machine
ON/OFF. The safety key is designed for emergency stop only and not to switch the treadmill
ON/OFF.
-
Noise compliance: This treadmill meets the requirements of the noise pollution standards.
-
Search for noisy parts: If you should notice unusual noises, like grinding, clacking etc. try to locate it
and have it repaired by a professional. Make sure the treadmill is not used until after repairs have
been made.
1.
Remove the treadmill and all components from the shipping box and remote the console until it is in an
appropriate position. Cut the cable tie, then lift the uprights (105/106) to the unfolded position and secure
using the bolts 2 x 601. Cover with cap 2 x 710.
2.
Attach the wheels to the base frame using 2 x 605 bolts and 2 x 606 washers.
3.
Connect the upper computer wire 413 to the lower computer wire 414. Do the same with the safety key
wire 415 and 416. Screw the console support tube on the uprights using 2 x 608 bolts.
4.
Fix the left and right side handlebar on the uprights using the 4 x 602 bolts
5.
Attach the upright cover 701/702/705 to the left upright and repeat the same on the right side.
6.
Use 14 x 604 screws to fix the upright cover.
Assembly
