FUNCTIONAL SPECIFICATION
The Video Level should be within the indicated range.
Levels that are too low will result in a dim picture with reduced dynamic
range.
A Video Level that is too high will result in washed out pictures with
decreased definition.
The Sync Level controls the drawing of each line on the monitor. Sync
Levels that are too low will cause the picture to breakup or roll while
Sync Levels that are too high will result in a picture with reduced grey
colours and dynamic range.
In an installation with multiple cameras, the video and sync levels
should be matched as closely as possible at the head-end to prevent
noticeable picture quality differences when switching between cameras
on a sigle monitor. Values outside the recommended tolerances can
cause the operators to experience eye fatigue.
VIDEO
:
Indicates if the input or output video signal system is NTSC or PAL.
Input video signal is output onto the LCD screen and automatically
switches to NTSC or PAL without using a special setup key. The
output video signal when in Pattern Generator mode can be switched
to NTSC or PAL, using the
key.
BRIGHT
Indicates screen brightness, and brightness increases by +1 when the
key is pressed, and decreases by -1 when the
key is pressed.
It returns to the initial setup value when either of the two keys is
depressed for more than 3 seconds.
CONTRAST
Indicates screen contrast, and contrast increases by +1 when the
key is pressed, and decreases by -1 when the
key is pressed. It
returns to the initial setup value when either of the two keys is
depressed for more than 3 seconds.
FUNCTIONAL SPECIFICATION
Introduction to the DVR Function [Rapport III-Pro]
Rapport III-Pro suports the DVR function.
1.
Selecting the DVR mode causes the DVR
(Rapport III- PRO)
to initially boot
up and after 2-3 seconds the start menu is displayed.
À
DVR MODE: Indicates DVR Mode.
Á
NTSC: Indicates NTSC or PAL System.
Â
Indicates Screen Mode. Shows REC when in record and PLAY (
►
)
when in playback, otherwise will display LIVE for real time images.
Ã
FILE NO: Indicates recoded file number.
Ä
EMPTY: No SD card installed.
IN : SD card has been installed.
Å
MODE: Change the mode.
24 25
Summary of Contents for Rapport III
Page 23: ...DRAWING mm MEMO 44 45 ...
Page 24: ......
