
Part 4 - Configuration
28
-
(Select) or (Clear): Click to select or clear a
block for motion detection. You can select or clear
the several blocks of an area using the mouse
dragging.
-
or (One or All block): Click to select or clear
one or all blocks at a time.
-
(Area): Click to select or clear several blocks of an
area.
•
Min. Blocks
: Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under
Zone
for daytime and nighttime, each.
•
Actions
: Specify which actions to take when motion
is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels.
-
Notify
: Configure to be notified of events by Mail,
Callback (LAN 1 through 5), SNS.
In order to use the Callback (LAN 1 through 5) feature,
the NVR must be registered on the remote program.
•
Motion Ignoring Time
: The system does not produce
event log entries or issues remote notifications
regarding motion detected during the specified time
following the initial motion detection.
Motion Ignoring Time does not affect motion
detection recording.
•
Daytime Setup
: Specify when daytime starts and
ends. Times outside the specified range will be
assumed as nighttime by the system.
Alarm-In
•
No.
: Enable / disable alarm-ins of network cameras.
•
Title
: Enter titles.
•
Type
: Change the alarm-in type.
•
Actions
: Specify which actions to take when Alarm-In
is detected.
-
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels.
-
Notify
: Configure to be notified of events by Mail,
Callback (LAN 1 through 5), SNS.
• In order to use the Callback (LAN 1 through 5)
feature, the NVR must be registered on the remote
program.
• Select
Panic Record
to specify which alarm-in
channels to use. Panic Record commences when
the corresponding alarm-in occurs and terminates
when the alarm-in is deactivated.