AK24 Quick Installation Guide (EN)
INSTALLATION
WALL MOUNT
1.
allow you match the bracket WB-24 for wall mount
1.
Locate the mounting template at the installation position and drill the wall.
2.
Remove the release paper of bracket pad and attach to rear plate of the bracket
3.
Route the power and BNC cable through the bracket
4.
Tight the bracket to wall through the four screws
5.
The cables will be through the Adaptor Plate;
6.
Loose the screws in the top of bracket, the adaptor Plate aligned to the rivet of bracket, rotate the Plate to
the right position, then tight the screws in two sides of bracket.
7.
Install the water-proof stopper and the cable through the installation hole of Junction Box
8.
Install the Junction box to the Adaptor Plate
9.
Connect the power and BNC cable with the camera cables
10.
Herein you can match bullet (NI/ND housing) or Dome(FG/RB housing) with the Junction
If you install the Vandal-proof Dome, Open the dome cover by loosening screws
11.
Assemble the vandal proof dome unit or Bullet base to the mounting plate using the assembly screws
12.
Set the camera’s viewing angle
13.
Put the dome cover to the dome unit and tighten screws.