10
2.1.2 Heater Kit Installation (Optional)
1. Assemble the Heater board to two bosses with screws.
Take it to a reference “B” in the bottom case as below.
2. Place the Heater in the slot “A”.
Heater cable should be placed away from the Main board.
3. Plug the power connector to the socket “C” (J1) of the Heater board.
4. 24VAC is recommended to use for the camera power for stable operation with heater kit.
• HEATER (IF APPLICABLE)
Power Supply
24VAC
Power Consumption
10W
Heater ON
at 59°F (15°C)
Heater OFF
at 77°F (25°C)
• POWER
Use Certified/Listed power source only.
CAUTION 1: D
ehumidify after installing the heater kit. Otherwise, moisture may be
generated at certain temperatures. Then close the cover tightly to ensure
waterproofing
.
CAUTION 2: Please reset the camera after 30 ~ 60 minutes when installing it in situations
colder than -10°C.