Eneo 220931, Quick Installation Manual, Page: 6 / 48

6
Installation
Installation
For the operation of the EoC network camera, it is necessary to connect a BNC cable for
data transmission and power supply. This EoC network camera must use a dedicated
receiver capable of data transmission and power supply through BNC cable. Depending
on operation methods, it is possible to connect an alarm cable additionally. For its fixation
on different locations, please consult with an installer.
The dome camera should be attached to a structural object, such as hard wood, wall stud
or ceiling rafter that supports the weight of the dome camera. For its fixation on different
locations, please consult with an installer.
Installing and Adjusting Camera
1. Loosen the 4 torx screws located on the front of the housing leaving the screws
intact in the front portion.
2. Using the template sheet make mounting holes and cable hole in the place (ceil-
ing or wall) to which the camera is to be installed.
3. Fix the bottom case to the mounting place using supplied Anchors (4x) and
Mounting Screws (4x).
Torx lock screw (x4)
Top case
Bottom case & camera