The RTP Port range defines the range of ports from which the video/audio ports
are automatically selected. This feature is useful if the camera is connected to a
NAT router with manually configured port mapping.
> Enable DDNS: Click the Enable DDNS checkbox to active DDNS service.
> DDNS server: Enter the DDNS server name.
The default DDNS server is security-device.name
> Registered host: Enter the registered host name.
> User name:
Enter the registered user name to be used for accessing the DDNS server.
> Password:
Enter user password to be used for accessing the DDNS server.
> Confirm password:
Enter user password again to confirm.
> Interval: Set the interval at which to regularly update the Dynamic DNS service.
The default setting is 1 hour.
Limit the range of ports permitted for RTP unicast/multicast by entering the Start
port and End port in the provided fields.
*
The video/audio ports entered here must be even values.
> Start port:
The Start port can be entered in the range 1024-65532. The default setting is 5008.
> End port:
The End port can be entered in the range 1024-65532. The default setting is 50999.
1) Multicast-Stream1~3:
Only IP addresses within certain ranges can be used for multicasting.
The camera has been pre-configured with addresses from these ranges, and does
not normally need to be reconfigured. If an address does need to be changed,
please contact your network administrator.
> Destination IP: Click in the destination IP box and type IP address.
Multicast addresses are allocated according to these IANA policies.
The default setting IP address is 231.1.128.20
*
The RTP port entered here must be even values.
TTL (Time To Live) If IP packets (i.e. data) fail to be delivered to their destination
within a reasonable length of time (which could be for various reasons), this setting
tells network routers when to discard the packet.
The value is usually measured in 'hops', i.e. the number of network routers that
can be passed before the packet arrives at its destination or is dropped.
> RTP port: The RTP port can be entered in the range 1024-65532. The default
setting is 5000.
> TTL: The TTL can be entered in the range 1-255. The default setting is 1.
●
RTP
61
Full Menu Setup
