Enecsys Single Repeater, User Manual

Page: 14 / 25

Single Repeater Installation Manual Intelligent Reliable Power
10
© ENECSYS 2010. All rights reserved.
2.3 Wall mounting the Enecsys Repeater (adhesive pad method)
When mounting an Enecsys Repeater always ensure that you have connected the power supply
and antenna to the device before the final fit. Locate the Enecsys Repeater away from metal
structures. The adhesive pad placement areas are shown in
Figure 5 on page 9 .
1. Ensure that the back-plate of the Enecsys Repeater and the wall or mounting surface is clean
from dust and grease.
2. Attach the antenna to the RP SMA plug on the right hand side of the Enecsys Repeater, screw
the antenna into place in a clockwise direction.
3. Connect the supplied external 5V DC power supply to a mains supply AC power source.
4. Connect the supplied external 5V DC power jack-plug to the DC power port on the reverse of
the Enecsys Repeater, thread the cable through the semi-circular channel on the back-plate of
the Enecsys Repeater, this will help to keep the cable in place and prevent it from becoming
detached.
5. Remove the backing material from one of the double sided adhesive pads and place firmly
onto the fixing points on the back of the Enecsys Repeater. Complete the process for the
remaining two double sided adhesive pads.
6. Remove the remaining backing material from the adhesive pads attached to the back-plate of
the Enecsys Repeater, press the Enecsys Repeater firmly into place on the wall/mounting sur-
face.