Page 9 of 9
8.
My LED light is not working properly : not turning on / only 1 side is on / etc.
-
Check to see if the connection is secure.
-
Charge the battery.
-
Use the remote controller to activate the signal.
9.
Pairing or re-Pairing between LED controller and a remote controller
-
This product is designed for an exclusive communication using 2.4G RF(Radio
Frequency) technology which enables 1 on 1 communication without any
interference from other devices.
-
Case 1) The LEDs on the back are not working (turn on) : More likely the LED
controller battery is dead. Recharge for 2 to 3 hours.
-
Case 2) Remote controller is not working (Blinker not working)
a) Make sure the battery in the remote is not dead : Coin battery(CR2032).
Push all 3 buttons on the remote for 1 second and the light should blink
on the remote.
If remote do not light up, replace coin battery(CR2032) and follow b.
b) Paring and re-Paring process
Turn on your LED controller first (make sure you only have one product
around you).
Push all 3 buttons and make sure the light flashes on the remote, then
turn off LED controller.
Turn on LED controller and push any button for pairing.
Wait 2-3 seconds, and your remote should work.
