Endress ESE 604 DHG DIN, Translation Of The Original Operating Instructions

Page: 40 / 92

Operate power generator ESE 604 DHG DIN
40
ESE 604 DHG (ES) DIN Status: October 2018
5.
Release the key switch (it springs back into the “OPER-
ATE“ position).
6. Move the choke slowly back into its start position.

The engine has started.
The electrical devices can be connected and/or hooked up af-
ter a warming-up phase of about one minute.
(Type No: 151022 / 151024)
See Chapter 5.4Remote start device
WARNING!
Devices with a remote start device are fitted with an au-
tomatic choke. You do not need to use the manual choke
(on the engine).
4.5
Switching the generator off
Proceed as follows to shut down the generator.
WARNING!
Hot parts can ignite flammable and explosive materials.

Avoid flammable materials at the operating site.

Avoid explosive materials at the operating site.

Allow the generator to cool down.
The device is switched off as follows:
1. Switch off or disconnect consumers.
2. Continue to run the engine for about two minutes.
3. Place the engine switch
(Fig. 4-2-
❹
)
in Pos. “0“.

The generator is switched off.
1. Switch off or disconnect consumers.
2. Continue to run the engine for about two minutes.
NOTE
When the special
equipment Remote Start is
installed
Switching the device off
A hand start
Electrical start