Endress ESE 2300 i, Translation Of The Original Operating Manual, Page: 37 / 60

38
Commissioning
Connecting up the
consumers 1. Place both generators next to each other in such a way that air supply and
removal are not impaired.
2. Connect the parallel connecting cable to both generators at the parallel
connection sockets .
3. Ensure that the parallel connecting cable does get disconnected during par-
allel operation.
4. Start both generators one after the other (see 7.4 Starting the generator).
5. Allow the generators to warm up until both are running evenly at a stable rpm
with a pressed in choke lever.
Parallel operation has been established.
You can now connect a consumer with a high power consumption to a protective
contact socket.
NOTICE!
When selecting power consuming equipment to supply, do not exceed the
maximum power output of the generator of 3,000 W (3,330 W for short time).
Take note of the fact that certain power consuming equipment (e.g. circular
saws, blowers, etc.) can significantly exceed their nominal output during
an increased start up current when starting. Details can be found in the
power consuming equipment’s operating manual.
7.8 ECOtronic (idle down)
Your Generators is fitted with an ECOtronic function. Fuel consumption
and emissions will be reduced when the ECO mode is activated, as the en-
gine speed is automatically adjusted to match the power requirement of the
connected consumer. This also leads to a reduction in the noise level. As
the power requirement increases, the engine speed will also increase to the
same extent and this ensures trouble-free operation of the connected con-
sumer. The electronics raise the engine speed again as soon as the con-
nected power consuming equipment is switched on in order to make the
full output available.
NOTICE!
Always switch the ECOtronic off before you operate a very powerful con-
sumer. The engine speed will increase up to nominal speed and provide full
power without any delay when you turn on the consumer.
Proceed as follows to run your Generators in ECO mode:
Requirements:  Generator is ready for operation

The generator is started (see Chapter 7.4 )
Switching on
ECOtronic Switch the idle engine speed reduction as follows:
1. Bring the rocker switch Fig. 6-4 into the "I“ (ON) position.
Idle down is activated. The engine speed will drop significantly when a consumer
is being run at a low power or is switched off.