Endress+Hauser Topclean S CPC30, Operating Instructions Manual

Page: 43 / 178

Topclean S 5 Operation
Hauser 43
5.1.3 Operation of the service switch
The service switch is located on the door of the CPG30 housing. There are two possible switch
positions:
!
Note!
The service switch always has priority (Emergency shutdown). This means that any running
programme is interrupted as soon as you operate the service switch.
"MEAS" switches to Operation. This displays the measured values. Use the arrow keys to scroll
through the different measuring menus.
!
Note!
Press "MEAS" to exit any of the "PARAM", "DIAG", "CAL" menus without terminating the settings
/ calibration.
"CAL" switches to the calibration menu of the electrodes.
"E" (Enter) moves you one step forward in a menu or confirms a selection you made.
LED (status display):
green: everything OK.
red: an error has occurred.
• You can scroll through the menu options with the arrow keys, and then highlight your selection
(if there is a choice offered)
or
• Increment or decrement numbers by one step with "+" / "-".
Move to the next digit with the "right arrow" (editor type 1) or
• "Activate" with the "right arrow" and scroll through the selection with "+" / "-"
(editor type 2) (for information on editor types, see page 46).
Service / Off:
(horizontal switch setting)
• The electrode moves into the rinse chamber.
• "Hold" is active for the outputs.
Measure / On:
(vertical switch setting)
After moving from the service position, a query appears asking whether a
programme should be launched or the electrode should be moved into the
process without cleaning.
Only those programmes are offered which have already been edited.