Soliphant T FTM260
Hauser
5
Power supply
Electrical connection
Screw terminals on electronic insert for max. 2.5 mm
2
wire in end sleeve A 2.5 - 7 to DIN 46 228
L00-FTM260xx-04-05-xx-xx-002
Electronic insert FEM31
Two-wire AC connection (thyristor)
!
Note!
Always connect in series with the load!
Check the following:
• the residual current in blocked state (up to 3.8 mA)
• that for low voltage
– the voltage drop across the load such so that the minimum terminal voltage at the electronic insert (19 V)
when blocked is not too low.
– the voltage drop across the electronic insert when open is observed (up to 12 V).
• that a relay cannot de-energise with a retaining current below 3.8 mA.
If this is the case, a resistor should be connected parallel to the relay.
Electronic insert FEM32
Three-wire DC connection (transistor,
PNP)
Designed to be connected to programmable logic controllers (PLC).
Positive signal at switching output of the electronic insert (PNP).
Electronic insert FEM34
Universal connection (relay, potential-free changeover contact)
Potential-free changeover contact.
Supply voltage
• Output with FEM31
Voltage at Terminals 1 and 2: 19...253 V, 50/60 Hz,
Current consumption (stand-by) max. 3.8 mA
• Output with FEM32
10...55 V, ripple max. 1.7 V, 0...400 Hz,
Current consumption max. 15 mA, protection against reverse polarity
• Output with FEM34
AC 19...253 V, 16...60 Hz or DC 19...200 V,
Current consumption max. 7 mA
1
2
L1 N
19...253 V
1 A
U~
1
2
3 (+)
L+ L–
–
a u r
L1 N
1
2
3 4 5
U– 10...55 V
U~ 19...253 V
U– 19...200 V
0.5 A
0.2 A
FEM 31
FEM 32
FEM 34
