Endress+Hauser Smart System SSP200B, Operating Instructions Manual

Page: 28 / 36

Commissioning Smart System for Aquacultures SSP200B
28 Hauser
Connection
at
transmitter Analog
input Measured value Factory configuration for
SSP200B-xx-FA
(freshwater) Factory configuration
for SSP200B-xx-FB
(salt water) or
SSP200B-xx-FC
(freshwater)
H AI 15 Sensor 8 primary value – –
AI 16 Sensor 8 secondary value – –
Modifying the settings for Ethernet
1. Select the Ethernet menu. Menu path: Menu > Setup > General settings > Advanced
setup > Ethernet
2. Select the Off option for the DHCP parameter.
3. Save the setting. Press the SAVE soft key to do so.
4. For the IP address parameter, configure the value 192.168.1.99 .
5. For the Subnet mask parameter, configure the value 255.255.255.0 .
6. For the Gateway parameter, configure the value 192.168.1.1 .
7. Save the settings. Press the SAVE soft key to do so.
8. Exit the Ethernet menu.
9. Check the settings in the System information menu. Menu path: DIAG > System
information
 The Liquiline CM444 transmitter can be found by the Modbus Edge Device and
read out data.
7.2 Commissioning the Modbus Edge Device
No settings need to be made on the Modbus Edge Device. Once the Liquiline CM444
transmitter has been configured successfully, the Modbus Edge Device connects to the
transmitter.
Checking the connection if necessary
1. Open the housing of the Modbus Edge Device →  17.
2. Check whether the LED A2 on the CPU (Kunbus RevPi3) is flashing irregularly
(→  18,  21).
3. Close the housing of the Modbus Edge Device →  17.
7.3 Adding devices to the Web application
All devices connected to the Modbus Edge Device are automatically created in the Cloud.
This can take up to 5 minutes. All the user needs to do is to add the Smart System to his
assets.
1. Call up the log-in page in the Web browser
https://iiot.endress.com/app/smartsystems .
 The "ID login" page is displayed.
2. Log in or register.
 Once the user has logged in successfully, the Assets page is displayed.
3. Select the Add function.
4. Enter the serial number of the Liquiline CM444 transmitter.
5. Enter the serial number of a connected sensor.