EA01097D
12
Hauser
8
Promag 400 remote version
8.1
Removing the transmitter
Proceed as described in Section 7.1, → 8 and in Section 7.2, Fig. 1 - 10. → 8
8.2
Assembling the transmitter
If the current transmitter has a connection board, this board must be installed in the new
transmitter. This is because the connection board contains the S-DAT with all the
sensor-related data. In this case, the jumper must be removed as indicated (Fig. 1
below).
1
Proceed as described in Section 7.3.1, → 10, Fig. 3 - 10.
8.3
Ambient temperature too high!
NOTICE
Danger of overheating!
Danger of electronics overheating and housing deformation.
‣
Do not exceed the permitted maximum ambient temperature.
‣
If operating outdoors: Avoid direct sunlight and exposure to weathering, particularly in
warm climatic regions.
‣
Excessive strain can damage the housing! Avoid excessive mechanical stress.
