Endress+Hauser Proline Promass F 100, Operating Instructions Manual

Page: 66 / 122

Commissioning Proline Promass F 100 Modbus RS485
66
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Assign process variable – Select process variable for
totalizer. • Off
• Mass flow
• Volume flow
• Corrected volume
flow
• Target mass flow
*
• Carrier mass flow
*
Mass flow
Unit totalizer One of the following options is
selected in the
Assign process
variable parameter (→  66)
of the Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Select process variable totalizer
unit. Unit choose list Country-specific:
• kg
• lb
Totalizer operation mode One of the following options is
selected in the
Assign process
variable parameter (→  66)
of the Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Select totalizer calculation
mode. • Net flow total
• Forward flow total
• Reverse flow total Net flow total
Failure mode One of the following options is
selected in the
Assign process
variable parameter (→  66)
of the Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Define totalizer behavior in
alarm condition. • Stop
• Actual value
• Last valid value Stop
* Visibility depends on order options or device settings
10.5.5 Using parameters for device administration
The Administration submenu systematically guides the user through all the parameters
that can be used for device administration purposes.
Navigation
"Setup" menu → Advanced setup → Administration
‣
Administration
Device reset →  67