Endress+Hauser Proline Promag W 400 HART, Operating Instructions Manual

Page: 103 / 198

Proline Promag W 400 HART Commissioning
Hauser 103
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Assign process variable – Select process variable for
totalizer. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
Volume flow
Unit totalizer 1 to n One of the following options is
selected in the
Assign process
variable parameter
(→  103) of the Totalizer 1
to n submenu:
• Volume flow
• Mass flow
Select process variable totalizer
unit. Unit choose list Country-specific:
• l
• gal (us)
Totalizer operation mode One of the following options is
selected in the
Assign process
variable parameter
(→  103) Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
Select totalizer calculation
mode. • Net flow total
• Forward flow total
• Reverse flow total Net flow total
Failure mode One of the following options is
selected in the
Assign process
variable parameter
(→  103) Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
Define totalizer behavior in
alarm condition. • Stop
• Actual value
• Last valid value Stop