Technical data
Proline Promag L 400 HART
142
Hauser
C-Tick symbol
The measuring system meets the EMC requirements of the "Australian Communications and Media
Authority (ACMA)".
Ex approval
The devices are certified for use in hazardous areas and the relevant safety instructions are provided
in the separate "Control Drawing" document. Reference is made to this document on the nameplate.
Drinking water approval
• ACS
• KTW/W270
• NSF 61
• WRAS BS 6920
Other standards and guidelines • EN 60529
Degrees of protection provided by enclosures (IP code)
• EN 61010-1
Protection Measures for Electrical Equipment for Measurement, Control, Regulation and
Laboratory Procedures.
• IEC/EN 61326
Emission in accordance with Class A requirements. Electromagnetic compatibility (EMC
requirements)
• ANSI/ISA-S82.01
Safety Standard for Electrical and Electronic Test, Measuring, Controlling and related Equipment
- General Requirements. Pollution degree 2, Installation Category II
• CAN/CSA-C22.2 No. 1010.1-92
Safety requirements for Electrical Equipment for Measurement and Control and Laboratory Use.
Pollution degree 2, Installation Category II
• NAMUR NE 21
Electromagnetic compatibility (EMC) of industrial process and laboratory control equipment.
• NAMUR NE 32
Data retention in the event of a power failure in field and control instruments with microprocessors
• NAMUR NE 43
Standardization of the signal level for the breakdown information of digital transmitters with analog
output signal.
• NAMUR NE 53
Software of field devices and signal-processing devices with digital electronics
• NAMUR NE 105
Specifications for integrating fieldbus devices in engineering tools for field devices
• NAMUR NE 107
Status classification as per NE107
16.13 Application packages
For an overview of the application packages that can be ordered, see the "Technical Information"
document
16.14 Accessories
For an overview of the accessories that can be ordered, see the "Technical Information"
document
