MMP20 SONO-DIS (option D)
Page 10
Hauser
6
Commissioning
Safety instructions
Caution:
Before you commission the device, make sure to read the general information at the start of
these Operating Instructions. Improper use can damage this device.
Checking the packaging contents
•
SONO-DIS handheld device
•
Power adapter (12V/2A)
•
Charging adapter
•
Protection cap
•
Manual
•
SONO-WZ probe
Charging the battery
The installed battery should be charged before the device is used for the first time. To do so, insert
the charging adapter provided into the 7-pin socket on the SONO-DIS. Then connect the power
adapter to the charging adapter. Charging commences immediately if the SONO-DIS handheld
device is already switched on or the battery is over-discharged. Otherwise, switch on the SONO-DIS
by pressing and holding the "Measure" key
for approximately 1 second. An animated battery
symbol on the display indicates that charging is active.
The built-in charging electronics charge the battery until it is fully charged. Charging takes around
2 hours if the battery was fully discharged. As soon as the battery is finished charging, all 4 "battery
bars" appear permanently on the display screen and trickle charging commences.
Caution: Only charge the battery at room temperatures (approx. 10°C to approx. 30°C)!
If the temperature is too low, end-of-charge cutoff might not work correctly and the
battery may be overcharged. If ambient temperatures are too high, the SONO-DIS
can be damaged by the heat generated during charging.
Connecting the probe
The SONO-DIS handheld device can be used with both the SONO-WZ moisture probe and the
SONO-M1 sand and gravel moisture probe:
Connect the SONO-WZ moisture probe to the SONO-DIS by inserting the 7-pin plug into the socket
provided on the SONO-DIS and tighten the union nut.
