Endress+Hauser Liquiline System CA80AL, Operating Instructions Manual

Page: 51 / 176

Liquiline System CA80AL Commissioning
Hauser 51
2
3 4
RB
RK
C
S1
P
W1
Cu
M
D
D5
D6
D7
5
RN
7
C S1
RK RB
RN
P
1
W2
2
optional
dilution
A0033652
 69 Liquiline System CA80AL, self-priming
RN Reagent RN M Photometer/measuring cell
C Cleaner Cu Cuvette
S1 Standard 1 P Sample
RK Reagent RK 2, 3, 4, 5,
7 Dispensers
RB Reagent RB D Outlet
W1 Outlet 1 T-piece
9.1.2 Connecting the sample inlet hose
1. Ensure a constant and sufficient supply of sample at the installation location.
2. Connect the liquid-bearing hoses of the sample supply system.
3. Self-priming system: connect the intake hose supplied (1.5 m (4.92 ft)) to the Liquid
Manager ("sample") (→  49) and guide it through the hose gland of the analyzer to
the outside.
4. If present, connect the communication cable and hose heater of the sample
preparation system to the analyzer.
5. Ensure that only sample that has a low solids content is supplied, as otherwise there
is a risk of blockage.
9.2 Function check
L
WARNING
Incorrect connection, incorrect supply voltage
Safety risks for staff and device malfunctions!
‣
Check that all connections have been established correctly in accordance with the
wiring diagram.
‣
Ensure that the supply voltage matches the voltage indicated on the nameplate.
Before putting the device into operation:
1. Connect the liquid-bearing hoses of the sample supply system.
2. If present, connect the communication cable and hose heater of the sample
preparation system to the analyzer.
3. After mounting:
Check all connections to ensure they are secure and leak-tight.