Endress+Hauser Liquiline Mobile CML18, Operating Instructions Manual, Page: 32 / 52

Operation Liquiline Mobile CML18
32 Hauser
8 Operation
8.1 Calibration
To calibrate sensors, the calibration settings are first configured via the SmartBlue app. The
calibration can then be started from the device.
Configure the calibration settings in the SmartBlue app:
1. Enable Bluetooth. →  26
2. Link the device to a mobile terminal via the SmartBlue app. →  20
3. Select the device in the SmartBlue App.
4. Navigate to:
Calibration settings
 Application >> Sensor >> Advanced settings >> Calibration settings
5. Configure the calibration settings.
 e.g. Manufacturer and calibration buffer.
Perform calibration on the device:
1. Navigate to: Guidance
 Select the desired calibration.
2. Press to navigate through the calibration.
The following calibrations can be performed:
Type of calibration Measuring parameters Navigate to:
1-point calibration ORP >> 1 point calib.
2-point calibration pH or ISFET >> 2 point calibration
Cell constant calibration Inductive/conductive conductivity >> Cell constant
Installation factor calibration Conductive conductivity >> Installation factor
Air 100%rH calibration Oxygen >> Air 100% rh
Air variable calibration Oxygen >> Air variable
1-point calibration Oxygen >> 1 point calib.
8.2 Reading measured values
Measuring screens are shown on the display when a sensor is connected.
For each sensor, there are 3 measuring screens with different measured variables→  19.
To scroll through the measuring screens:
‣
Press .
After the last measuring screen, the display returns to the first measuring screen.