Endon
LS9 0SE
20150324
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Assembly / user instructions
W28 18v1
Diagram A
Diagram B
Diagram C
1. Determine the position of your light fitting taking into
account the entry position of the cable and make sure
there is sufficient cable coming out of the wall to
connect to the terminal block. Ensure that the mounting
surface is solid, preferably a brick or block wall and
ensure that there are no other cables or pipes beneath
the surface.
2.
Diagram A.
Fit the 2 threaded posts in the back plate
and bring the mains cable through the rubber grommet
then use the back plate as a template and mark the 2
fixings holes, making sure the back plate is correctly
aligned so that the threaded bolts are horizontal. Use
appropriate fixings to secure the back plate to the wall.
3.
Diagram B
. Connect the house wiring to the internal
terminal block. The cable entry grommet must be
securely in place to ensure that the water ingress
protection is maintained.
NOTE:
This is a Class I
fitting and
must be earthed.
Connect the incoming
mains as per the diagram.
4. Diagram C.
Fit the terminal block onto the post in the
back plate and then fit the front frame over the 2
threaded bolts in the back plate and secure with the 2
threaded nuts. Take care not to trap or strain the
internal cables.
5.
Diagrams D and E
. Open the lid as shown. Secure the
finial to the top of the lantern shade. Fit the appropriate
bulb into the lamp holder
NOTE:
Never fit a bulb of a
higher wattage than that specified on the label (as
this may cause overheating and damage the
fitting).
Close and secure the lid.
6. Turn on the power and test.
Diagram D
Diagram E
Threaded bolts
Fixing screws
Grommet
Terminal post
Threaded nuts
Finial
