1.
Diagram A.
Determine the
position of your light fitting.
Ensure there is sufficient power
cable to connect to the fitting –
we recommend at least 250mm.
Ensure that the mounting surface
is solid. If you are using anchor
bolts (not supplied) prepare the
mounting surface as appropriate
(and ensure that there are no
other cables or pipes beneath the
surface).
2. Place the base over the cable and
use it as a template to mark the
mounting hole positions. Drill and
plug the holes ready to mount the
fitting later.
3.
Diagram B.
Pull the terminal
block assembly (1) out of the
base of the fitting. Remove the
cable clamp and take the lid off
the terminal block housing to
expose the internal terminal
block.
4.
C
onnect the house wiring to the
internal terminal block.
NOTE:
This is a Class I fitting and
must be earthed.
Connect the
incoming mains as per the
WIRING DETAILS
diagram
5.
Re-fit the terminal block into its
housing and secure – ensuring
that all seals are correctly
located.
6.
Secure the cable clamp (2) over
the incoming cable and then push
the terminal block assembly as
far into the base / stem as
possible.
7.
Secure the post (screws / bolts
etc not supplied) to the mounting
surface making sure that all
cables are contained inside the
fitting.
8. Remove the lid (3) by removing
the 2 x screws (4). Fit the bulb –
type given on product label. Re-fit
the lid
9. Turn on the power and test.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Assembly / user instructions
Endon Lighting
LS9 0SE
20141103
N210 115
Diagram A
Diagram B
WIRING DETAILS
