Endon Renner 6-Light Flush Fitting Instruction Manual Download Page 2

Page: 2 / 2

Endon Lighting, LS9 0SE

5. Support your fitting and connect the house wiring to the terminal block (2) – see wiring details.

NOTE:

This is a Class I fitting and must be earthed

. The 4th terminal block connector is used for the “loop”

wires of the “Ring Circuit”. There may be more than one set of cables in the “loop” connections.

If there is

a “Ring Circuit” and you do not understand the connections you must consult an electrician.

Any

loose terminal blocks –not secured to ceiling cup - should always be covered with 2 layers of good quality

insulation tape.

6. Secure the fitting back onto the fixing bracket with the 2 side screws (3), removed in 2 above. Make sure that

all the internal cables and connections are inside the ceiling cup taking care not to trap or strain the internal

cables.

7. Fit the decorative drop assemblies (6-8) as shown.

8. Fit the bulbs (9) into the lamp holders being careful not to touch the bulbs with your bare hands – use a cloth

or gloves to insert the bulbs.

NOTE: Never fit bulbs of a higher wattage or of a type other than those

specified on the label (as these may cause overheating and damage the fitting).

9. Turn on the power and test.

Assembly/ User Instructions Continued

57509-Renner6lt-F 20160429

X1pcs

X20pcs

X15pcs

X10pcs

X5pcs

Summary of Contents for Renner 6-Light Flush Fitting

Page 1: ...retain for reference Check the packaging and make sure that you have all the required parts Follow each assembly step in order to prevent incorrect assembly Ensure that the product is fully assembled...

Page 2: ...ality insulation tape 6 Secure the fitting back onto the fixing bracket with the 2 side screws 3 removed in 2 above Make sure that all the internal cables and connections are inside the ceiling cup ta...