Assembly/ User Instructions Continued
Endon Lighting, LS9 0SE
5. Connect the supply wiring to the terminal block (5). When you are sure of the connections wrap the Terminal
Block and overlap the wiring both sides with 2 layers of insulation tape.
NOTE: This is a Class I fitting and
must be earthed
. Any loose terminal blocks - not secured to ceiling cup - should always be covered with 2
layers of good quality insulation tape. Re-fit to the fixing post ensuring no wires are damaged, trapped or left
exposed. Check the seal, use sealant if required
6. Secure base to using ground anchor bolts (1&2).
7. Fit the bulb (6), then fit the lid (7) using the screws.
NOTE: Never fit bulbs of a higher wattage than those
specified on the label (as these may cause overheating and damage the fitting).
8. Turn on the power and test.
YG-3504-Drayton-Bollard 20160204
