Assembly/ User Instructions Continued
Endon Lighting, LS9 0SE
4.
Use the fixing bracket (D) as a template to mark the screw holes, and secure to the wall with appropriate screw
fixings (F), making sure the bracket is correctly aligned. Take care to avoid damaging any concealed
wiring or pipes.
5. Bring the mains cable through the rubber grommet. Connect the house wiring to the internal terminal block
(G) – see expanded wiring details below.
NOTE: This is a Class I fitting and must be earthed.
The cable
entry grommet must be securely in place to ensure that the water ingress protection is maintained. When
you are sure of the connections wrap the Terminal Block and overlap the wiring both sides with 2 layers of
insulation tape.
6.
Refit the wall back (C) with the two screws (E) set aside earlier.
7. Fit the bulb (H - not supplied).
NOTE: Never fit bulbs of a higher wattage than those specified on the
label as these may cause overheating and damage the fitting.
8.
Refit the shade (A) with the six screws (B) set aside earlier.
9. Turn on the power and test.
53803-Breton-WB 20180621
A
B
C
D
E
F
G
H
