8
Push Button Functions
DC/AC
Button
Press this button to select the following functions:
AC/DC Voltage & Current Diode/Continuity
°C/°F
.
RANGE & Stroke 4/2(DIS) ms TRIGGER
±
DC OUTPUT/
Square wave output
BUTTON
Press this button to select:
RPM x 10 RPM position
STROKE 4 2 DIS
ms-Pulse
TRIGGER
±
Signal Ouput
DC Output / Square Wave Output
V/A Resistance Position
Manual Range
Manual Ranging
The meter turns on by default in the autorange mode. Press the Range button
to change to manual ranging. The icon "
" will appear. Each press of the
range button will step to the next range as indicated by the units and decimal
point location. Press and hold the Range button for two seconds
to return to
autoranging
.
NOTE:
•
If the range is too high, then readings are less accurate.
•
If the range is too low, the meter will show OL
(over limit).
Data Hold
The
Data Hold
feature stores the last reading in memory.
•
Press the
HOLD
button once to hold the present reading.
•
Press the
HOLD
button again to exit and resume readings.
Always select a range higher than you expect the measurement to be. Then
select a lower range if better accuracy is needed.
•
If the range is too high, then reading are less accurate.
•
If the range is too low, the meter will show OL (over limit).