ENDA ET1413A Manual Download Page 2

°C

  ET1413A

ENDA

SET

A/C

FAN2
LED

FAN1 
LED

Air-Condition LED

 (A/C) 

If air-condition is working,this LED lights up.

SET

In run mode,this button is pressed once,while no fan has been deactivated ;fan1 engaged,this 
button is pressed again ;fan1 is switched off and the fan2 is engaged.
In programming mode; set the parameters for selecting parameters and values are constantly 
increasing provides.This key is pressed,set the numerical value increases
rapidly.

Terms

In run mode, the     key is pressed, the programming mode is entered, the parameter has been
selected;shows the value of parameters.  To set the selected parameter;      key held down while pressing
        keys  set the parameter values. In run mode,press the       key once the air-condition (A/C) LED is
lights up and air-condition is engaged.       key is pressed once again, A/C LED goes off and the air-condition
will be disabled. 

SET

SET

SET

SET

Pressing  this key once while in running mode;fan2 is switched off.Once again this button is 
pressed;fan1 is deactivated.
In programming mode,reducing the value of selecting parameters and the set.If this key is pressed
continuously,set the numerical value decreases quickly.

-

110

-

0

 and 

 

110

.

0

°C parameters can be 

adjusted to the desired of the specified value. 

 

Lol.I

 and  

upl

.

 

parameters can be adjusted

to the desired value of the specified value.

Adjustable between 

0

-

20

°

C. 

Temperature
set value

The lower limit
of the setpoint

Measurement
temperature

SET

Programming Mode

Initial Value

Run Mode

SET

SET

SET

SET

 If the     key is pressd once,the
A/C LED turns on and air-condition
is activated. 

 

 If the     key is pressed once,the  A/C LED turns off
and air-condition will be disabled. 

SET

 A/C LED

If a key is pressed within 5 seconds,the mode of
operation will be resumed.

set

lol.ý

upl

 

ý

.

hy5

.

The upper limit
of the setpoint

Hysteresis value
for the set value

15.0

22.0

.

22.0

22.0

.

-

50.0

°C and 

upl

.

 pa

rameters can be adjusted

to the desired value of the specified value.

SET

50.0

110.0

5.0

key is pressed for 3 seconds, the programming 
mode is entered.

The device when it receives power,air-condition output is
not active.
A/C output,begins in closed position To activate the A/C output;
the SET key must be pressed once.

  

HYS

 Pfa

Means, thermostat probe is short-circuit.

 PsC

Means,thermostat probe is broken.

Error Messages

Temperature value is higher than the scale.

Temperature value is lower than the scale.

    

E

T1

4

1

3A-E-01

2/2

Output Table

t

A/C Output (air-condition output)

   SET 

+

    

           SET

SET

SET

Reviews: