Encore Rage ER32FS600VL, Operator'S Manual

Page: 35 / 44

35
TROUBLESHOOTING
IMPORTANT: It is essential that all operator safety mechanisms be connected and in proper operating condition
prior to mower use.
When a problem occurs, do not overlook the simple causes. For example, starting problems could be caused by
an empty fuel tank.
The following table lists some of the common causes of trouble. Do not attempt to service or replace major items
or any items that call for special timing of adjustments procedures. Have this work done by your Service Dealer.
PROBLEM POSSIBLE CAUSE
Engine will not start or is Hard To Start No Fuel
Controls are not positioned properly for start
Air Filter or Air Screen is Dirty
Faulty Spark Plug
Improper Fuel
Stops Suddenly or Lacks Power No Fuel or improper Fuel
Engine Overloaded
Dirt in Fuel Line
Air Filter or Air Screen is Dirty
Incorrect Oil Level
Blocked Fuel Filter
Engine Overheats Engine Overloaded
Dirty Air Filter or Air Screen
Dirt in Fuel Line
Incorrect Oil Level
Mower Pulls Left or Right Unequal Tire Pressure
Tracking Adjustment Incorrect
Mower Cuts Unevenly Unequal Tire Pressure
Deck leveling Incorrect
Blades Dull or Damaged
Mower Deck Not Engaging Belt is damaged or has slipped
Clutch fuse failure
Mower Vibrates Blades Dull or Damaged
Engine Bolts are Loose
Mower moves slowly or not at all Drive belt for Hydraulic is loose or has slipped
Linkage loose
Bypass valve on pump is open
Hydraulic Oil Leakage Damaged Seals or gaskets
Air in Hydraulics
Axle Reservoir over full