Encore Networks EN-1000 Series, Quick Configuration Manual

Page: 5 / 8

EN-1000™ Quick Configuration Guide Page 5
Go to Top
Document
c Configure the parameters for the WAN protocol you selected.
d When you are satisfied with the parameters, select the Save & Apply button (in the
lower right corner of the screen).
❖
The configuration is saved and the EN-1000 reboots. After rebooting, the log-in
screen is displayed.
e Go to Using the EN-1000’s Configuration , on page 7.
Configuring the EN-1000 as a Cell Router
Make sure you have performed step 6b on page 3.
Application Configuration Screen to use EN-1000 in Cell Router Mode
8 Do the following when the EN-1000 will perform as a cell router:
a Modify the following parameters, if required:
• Device Name
• LAN IP
• LAN Netmask • LAN DHCP Server
• VPN Mode
• enCloud Enabled
b When you are satisfied with the parameters, select the Save & Apply button (in the
lower right corner of the screen).
❖ The configuration is saved and the EN-1000 reboots. After rebooting, the log-in
screen is displayed.
c Go to Using the EN-1000’s Configuration , on page 7.
Parameters
Displayed
WAN Protocol
DHCP Client PPPoE Static
PPPoE Username •
PPPoE Password •
WAN IP •
WAN Netmask •
WAN Gateway •
DNS Server •
Failover Ping IP • • •
Failover Ping Timeout • • •
Failover Ping Retries • • •
VPN Mode • • •