4.2.6.
Setting-Cooling
Figure 4-7 Setting-Cooling page
"ON/OFF" It is set to start and shut down the cooling unit.
Note: Cooling ON and OFF has a delay, wait for it to complete.
"Control Mode " means the temperature which controls the operation of the
cooling unit. You can choose to supply air or return air.
"Fault reset" When there was the Cooling alarm, and the fault has been resolved,
you can use this button to reset and cancel the alarm state.
“Fault Reset” Click here to reset when a manual reset is required in case of a
cooling alarm.
"Temp Setting 28.00
℃
” is the temperature to control the inverter compressor and
fans for operation.
"Temp Band 6.00
℃
" is the parameter that cooperates with the temperature to
control the inverter compressor and fans for operation.
"Humid Setting" and "Humid band" are the parameters to control the operation of
the humidifier, which is an optional component.
4.2.7.
Log
This part is the data record center for the key components such as UPS, Cooling,
Environment, Sensors, and album. The pictures in the album are taken by the
camera built-in to the HMI screen. The data for different components could be
selected via the vertical bar on the left side.
It defaults to showing the data of the current day, and You can select the data of
one day in "XXXX-XX-XX" or click "Previous Day" and "Next Day" to view the data
of the previous day and the next day.
Below please find the schematic of the UPS for example.
36
