ASSEMBLY INSTRUCTIONS
RACK ASSEMBLY
1)
Place the
arched upright
on a flat surface with the two bends, which form the two front leg supports,
pointing down.
2)
Attach the two
back leg supports
to the arched uptight opposite the front leg supports using the
1/2'”
button head screws.
Insert the
button head screws
through the front of the
arched upright
and into
the
back leg supports
using the
hex key wrench
supplied.
4)
Note:
The screw holes in the
back leg supports
are threaded so they must receive the
button head
screws
last.
5) Square up your tool set and tighten the button head screws using the hex key.
6) Hang the three tools in this set on the notches in the arched upright. Your rack is now complete.
It is important that your tool set is assembled correctly. If the set is assembled or
used incorrectly, it could become unstable and collapse, possibly causing injury.
Also natural broom straw is flammable. So you must keep the broom well away
from open flame. And for sure it should not be used to sweep hot coals or ash.
WARNING
Limited Warranty:
This product is warranted to be free of material defects for a period of five year from the date of purchase. Your exclusive remedy is the repair
or replacement of the defective product, which is subject to the following conditions: (1) Your written notice of any defect is received by Enclume within the
warranty period, and (2) You return the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339
, postage prepaid
within
20
days
following your receipt of a return authorization number from Enclume (which number may be obtained by telephoning the number below).
There are no other warranties, expressed or implied.
THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PORPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE
PURCHASE OR USE OF THS PRODUCT.