Décor Compact Scroll Rack
DR 23
Thank you for selecting Enclume.
Our Décor racks bring you the best in
Quality, craftsmanship and style.
You will not be disappointed with one of
The finest cookware storage racks made.
WARNING: PLEASE READ
ALL OF THESE INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR RACK
E
nclosed you will find everything needed for
the assembly and use of your pot rack.
Two
people make assembly and installation much
easier.
The parts and hardware included are:
Hardware included:
2 – Ceiling Hooks - small
2 – 2-inch “S” Hook
2 – 6” Décor Chain
8 – 1/4” x 3/8” Button Head Screws
2 – Barrel Screws, #10 x 24 x 7/16”
2 – Barrel Nuts, #10 x 24 x 5/16
2 – 5 /32" Hex Key Wrenches
1 – Toggle Kit, 2 point x ¼”
ASSEMBLY INSTRUCTIONS
1) Unpack the rack, spread out the contents, and match these parts to the hardware and component lists above. If any
item is missing, please call our customer service line at 1-877-362-5863 to receive replacements.
2) Place the rack components on a firm, flat surface. You can protect the surface with the corrugated shipping box.
3) Identify the four arms and determine the lower end of each arm – this is the section on the arm where a screw hole is
made on a flat area (check the diagram above).
4) Identify the oval rack body. Using four of the ¼” x 3/8” button head screws and the hex key wrench, loosely attach
the lower ends of the four arms, one at a time, to the outside of the oval body as shown in the diagram above.
5) Now locate the upper hang bar (this is the bar with two large and two small holes in it) and the set of two barrel
screws and two barrel nuts. Place the upper hang bar between the tops of the arms (which form two arm pairs) and
insert one barrel nut: 1) through the top hole in one arm, 2) then through the upper hang bar, and finally 3) through the
hole in the other arm of the pair. Holding this assembly in place, insert the barrel screw into the barrel nut and loosely
attach with the hex key wrench.
6) Repeat the process set out in step 5) to attach the other arm pair to the upper hang bar using the remaining barrel nut
and barrel screw.
7) Next locate the two lower side bars. One side of the rack at a time, attach a lower side bar to the inside front of the
lower scrolls of the two arms on one rack side. Attach with two of the ¼ x 3/8 button head screws, inserting the screws
through the outside of the arm scroll and driving them into the lower side bar with the hex key wrench
Components included:
4 – Arms
1 – Oval Body
2 – Lower Side Bars
1 – Upper Hanging Bar
6 – Pot hooks - EPHS
6 – Pot hooks - DRPHS
