I
NSTALLING
T
HE
865X PRO P
O
E E
XTENDER
K
IT
We highly recommend that you perform a quick out of the box test to ensure the working order of your
Enable-IT 865X PRO Gigabit PoE Extender units prior to installing. This will also serve to familiarize
you with how easy the process should be. Follow the steps below to perform the Out Of the Box Test.
Step 1
- Attach the 60W 56V DC Gigabit PoE Injector and power adapter to the local 865X PRO unit and
power up the unit. The Power LEDs will indicate the injector and 865X PRO unit is receiving power.
Step 2
- Connect the 865X PRO RJ-45 Interlink ports together using one of the Ethernet LAN Patch cords
provided – as shown by the green line connecting the ports in the diagram above.
The Green LED Sync indicator on each of the 865X PRO units will blink as they see each other and
then go solid once they are synched together.
Left side LEDs
Mode
– Yellow Solid LED (LED Off = CO unit, LED On = CPE unit)
Sync
– Green slow to fast flicker LED on power up – indicates negotiation of a link
– Green solid LED indicates link established and rapid pulse is traffic.
Power
– Green Solid LED indicates the unit is receiving 12V power.
Right side LEDs
Act
– Yellow LED
Off
= No device attached or detected.
On
= Solid, indicates the presence of local LAN.
Blinking = Indicates the presence of local LAN traffic.
The Green Sync LEDs will start flickering slowly and then fast as the units talk to each other. After a
few seconds you should see a solid Green Interlink Sync LED on each unit to confirm a link is
established. This confirms basic proper operation of the units.
All Rights Reserved © 1997 - 2020 Enable-IT
™
, Inc. Page of
2
7
The Enable-IT 865X PRO Gigabit PoE Extenders have a distance restriction of 3,000ft (915m) over 1-
pair of copper wiring from device extension to device extension.
Therefore a site survey of the wiring and installation planning are highly recommended.
For highest performance use 100Mhz rated for the interlink wiring.
