Software Setup
DIMM-Base provides a generic connector for TFT-Displays (including touch panels). Each display kit
includes a TFT-Display, a touch panel (resistive or capacitive) as well as an adapter in order to directly
connect the kit to DIMM-Base Verno.
Display Kit
Congratulation! You have now connected your emtrion Developer Kit to the Host PC and you will shortly be
able to start application development.
Please continue the installation process using the software manual in the „documents“ folder on the DVD in
order to get the development environment up and running.
Install Software
DIMM-Base Verno provides two RS232-UART interfaces on DB9 connectors. DIMM modu-
les provide more than two UART and these additional UART are available as TTL signals
on headers. ADA_232 is an adapter cable that can be directly plugged into the headers
to provide RS232 signals on a DB9 connector.
DIMM-Base Verno provides up to two CAN busses as TTL signals on headers. ADA_CAN
is an adapter cable that can be directly plugged into the headers and that integrates a
high speed CAN transceiver and provides a DB9 connector.
DIMM-Base provides two connectors for CMOS camera sensors. This camera set includes a CMOS
camera sensor, an objective and an adapter cable to directly connect it to DIMM-Base Verno.
This small adapter includes some LEDs and buttons that can be controlled by the CPU‘s GPIOs.
ADA_RS232
ADA_CAN
Camera Set
ADA_VERNO-GPIO
Additional Equipment
emtrion also provides direct support for hardware and software, as well as workshops and trainings.
Feel free to contact us at
.
Additional technical information can be found at
http://support.emtrion.com
.
Additional Service
Support
V1 11/2012
emtrion GmbH
Alter Schlachthof 45
D-76131 Karlsruhe
Tel. +49 (0) 721 62725-0
Fax +49 (0) 721 62725-19
E-Mail [email protected]
Visit us online at:
www.emtrion.com
