1. Check Battery:
Proceed to insert battery pack into the battery compartment. BE SURE TO MATCH THE
POSITIVE AND NEGATIVE ENDS OF THE BATTERY PACK TO THE MARKINGS IN THE
BATTERY COMPARTMENT OF THE UNIT.
NOTE:
Before first and consequent uses, charge battery using the supplied battery charger.
To charge: Plug male end of charger to the socket located on the right side of the LCD screen.
Make sure the plug fits snugly into the socket. PERMANENT DAMAGE MAY OCCUR IF FORCE IS
USED TO PLUG THE MALE END OF THE CHARGER INTO THE SOCKET. A green indicator
on a fully discharged battery), a green steady light will illuminate. Typical charge may last 2 hours of use
depending on frequency and intensity of treatment.
NOTE:
charger plug is plugged into an outlet. Once charged or not in a charging mode, disconnect the plug from
the device. Use of unapproved charger (not issued by EMSI) may cause damage to device and will void any
warranty.
CONNECTING THE STIMULATOR
2. Connect electrodes to lead wires:
Insert the lead wire connector into electrodes connector (standard 0.08 inch female connection).
MAKE SURE THAT NO BARE METAL OF THE PINS IS EXPOSED
10.0
| Instructions For Use
NOTE:
Always read this instruction manual before use.
PREPARATION FOR USE
17
