SOUNDERS
FAULT
ZONE/RESET
EOL L1 L2
EOL L1 L2
ALARM
RES
EOL L1 L2
1 Introduction
6 Connection wiring
2 Pre installation
Part no Product description
EC-63-0001
EMS Conventional Interface Card
Conventional Interface Card (CIC)
Installation Guide
3 Connect CIC to the ZIM
5 Fasten the ZIM’s terminals
SOUNDERS
FAULT
ZONE/RESET
EOL L1 L2 EOL L1 L2
ALARM
RES
EOL L1 L2
(+) (-) (+) (-) (+) (-) (+) (-) (+) (-)
(+) (-)
(+) (-)
SOUNDERS
FAULT
ZONE/RESET
EOL L1 L2
EOL L1 L2
ALARM
RES
EOL L1 L2
The CIC can be wired in two different ways.
Fault notification can either be monitored via the conventional
fire panel’s sounder or zone circuit.
See overleaf for the alternative wiring methods.
Ensure the pins line up with the ZIM’s terminal connections as
shown.
!
Installation must conform to applicable local installation
codes and should only be installed by a fully trained
competent person.
Only fit the CIC to the zone interface module
(ZIM)
, when
connecting to a conventional fire panel.
The CIC should only be connected to designated zone and
sounder circuits.
Refer to the EMS wireless zone monitor engineers guide
(TSD143)
for full programming information.
Refer to the conventional control panel compatibility document
(MK58)
for details of compatible conventional fire alarm panels.
This device contains electronics that may be susceptible to
damage from electrostatic discharge
(ESD)
. Take appropriate
precautions when handling electronic boards.
ZIM with
CIC fitted
WZM
ww
w .ems
gr
ou
p.c
o.u
k
Radio D
etec
tor Base
PRESS HERE T
O
L OG ON
IDENT
FireCell wireless devices
POWER
FAULT
WIRELESS ZONE MONITOR
FC-ZIM-001
Conventional
fire panel
The conventional interface card
(CIC)
when fitted to the zone
interface module
(ZIM)
, enables 30 FireCell wireless devices to be
added to an existing conventional fire panel, via a wireless zone
monitor
(WZM)
.
*
*
Designated zone
and sounder circuits.
4 Fasten the CIC PCB into the ZIM
©2021 EMS Ltd. All rights reserved Page 1 of 2
TSD147-99 Iss 6 15/12/2021 AJM
