Controls at a Glance
stompswitch:
function assigned by the stomp function
toggle swith. Can engage/disengage the boost, switch
between A and Y, or A and B. Hold for 1 second to mute
out 1 and out 2 for silent tuning.
stomp function:
sets the function of the stomp switch. In the boost
position, the stomp switch will toggle the boost circuit on and off. In
AB position the stomp switch will toggle the active output between
out 1
and
out 2
. In the AY position the stomp switch will toggle the
active output between
out 1
and both
out 1
and
out 2
.
*note: some modes do not incorporate all of the different stomp functions. In
those cases the toggle switch will not have any effect on the stomp function.
input pads:
pads the input by either 6dB or 12dB. This can be
useful for padding a very hot signal from an fx loop or active
instrument. It can also be useful for matching levels from different
instruments (ie. passive and active pickups, or single coil and
humbucking guitars).
input LEDs:
illuminate green when signal is present. If the signal
gets too hot and clips the input, a red clip indicator LED will
illuminate and hold for 2 seconds.
boost:
sets the amount of boost to be applied when
the boost is engaged. Ranges from 0 to +30dB.
Summary of Contents for buffer plus
Page 1: ...user manual...
