37139-8-1219
Page 9
You must secure the gas burner to the firebox floor. If not, the
entire unit may move when you adjust the controls.
1. Center the gas burner in the fireplace or firebox. The burner
must clear the firebox screen.
2. An anchor hole is provided in the two bottom side burner. After
centering the burner correctly, mark the hole positions on the
firebox floor. Drill two (2) 5/32" diameter holes approximately
1-1/2" deep for masonry screws or 1/8" hole for sheet metal
screws.
3. Anchor the burner to the firebox floor using the screws pro
-
vided.
ANCHOR SCREWS
Figure 1
BEFORE FULLy INSTALLING THE APPLIANCE
Minimum Dimensions For Solid Fuel Burning Fireplaces
Model
A
B
C
D
OLI-24
28"
15
9/16
"
34
5/16
"
24
3/16
"
OLI-30
32"
15
9/16
"
38
5/16
"
24
3/16
"
The dimensions shown and defined in the fireplace instructions are
minimum clearances to maintain in installing this heater. Left and
right clearances are determined when facing the front of the heater.
Glass Doors
Make sure that glass doors are open during all operations of the
appliance. The opening of the glass door frame should be the
dimension used for the minimum front opening of the firebox.
Follow these instructions to ensure safe installation.
Failure to follow instructions exactly can create a fire hazard.
CLEARANCES
SPECIFICATIONS
Model
OLI24P
OLI24N
OLI30P
OLI30N
Input BTU/Hr Maximum
36,000
36,000
40,000
36,000
Input BTU/Hr Minimum
28,000
27,000
28,000
27,000
Orifice
#50
#31
#49
#31
Air Shutter Opening
FULL OPEN
1/8" OPEN
FULL OPEN
1/8" OPEN
CONVERSION KITS
Model
Propane
Natural
OLI24
32001
32002
OLI30
32003
32004