35430-0-0315
Page 13
ASSEMBLY
FOR EMBER BED INSTALLATIONS
1. Insert the bottom lip of the ember burner pan under the ember
burner. See Figure 9.
2. Push the ember burner pan backwards, towards the main
burner, centering the top of the ember burner pan beneath the
grate support. See Figure 10.
Figure 9
Figure 10
You must secure the gas burner to the fireplace floor. If
not, the entire unit may move when you adjust the controls.
Movement of unit may cause shifting of the gas logs which
leads to sooting and improper burning. Grate movement
could cause a gas leak.
Special care is required if you are installing the unit into a
sunken fireplace. You must raise the fireplace floor with non-
combustible material to allow access to gas log controls.
This will ensure adequate air flow and guard against sooting.
Raise the fireplace floor using noncombustible materials.
Assembly Procedure:
1. Place the burner in the fireplace or firebox. Make certain the
entire ember burner is inside the front edge of the fireplace
or firebox.
2. An anchor hole is provided in the two bottom side members
of the grate frame. After centering the grate correctly, mark
the hole positions on the fireplace/firebox floor. Drill two 5/32-
in. diameter holes approximately 1-1/2" deep for masonry
screws or 1/8-in. hole for sheet metal screws.
3. Anchor the grate to the fireplace/firebox floor using the
screws provided. Refer to Figure 11.
Proper installation of the grate is essential to prevent any
movement of the gas logs and controls during operation.
Figure 11
BEFORE FULLY INSTALLING THE APPLIANCE
