background image

26592-0-1009

Page 3

Proper Log Placement

Log placement is critical to proper burner performance. Logs must 

be correctly positioned onto the burner. The photos in this manual 

show the proper pinned position for logs on this set. Owners need 

to be shown proper log placement and instructed not to move the 

logs. 

Logs must fit firmly onto the burner when positioned as shown in 

the photos. Malformed logs or logs with sloppy pin holes must be 

replaced.

Proper Placement of rock wool and Decorative Lava rock

Rock wool can be added to burners for a glowing ember effect. 

It must be positioned only on the front portion of the burner. The 

photos in this manual  show the proper placement of rock wool.
Decorative lava rock or small wood pieces should never be placed 

on the burner. These items are only for placement on the floor of 

the fireplace.

Proper Primary Airflow into Burner

For  proper  burner  operation  and  flame  appearance,  the  flow  of 

primary air into the venturi tube, located on the rear of the burner, 

must not be reduced. This flow of air is reduced if dirt, lint or other 

obstructions build-up around or inside the venturi. Any obstruction 

in the venturi tube area must be removed. The flow of air into the 

venturi is also reduced if the gas orifice isn’t centered in the venturi 

inlet and/or is not aligned with the venturi. Any misalignment of the 

burner orifice may be corrected by bending the shutter cap holding 

the orifice to the inlet of the venturi tube.

ceiling Fans, Portable Fans or Logs Installed Near cold Air 

returns

Ceiling fans or oscillating floor type fans need to be monitored 

during the operation of vent-free logs. If the air blows directly 

into the flame causing it to impinge on the log set, or firebox, it 

should be turned off or redirected. Ceiling fans could be reversed 

to possibly eliminate flame impingement, and the floor fan could 

be redirected. Upon installation, be aware of any cold air returns 

or vents in the proximity of the log set. Any draft created around 

a vent-free log set can cause the flame to impinge on the log and 

create a sooting situation.

wArNING: 

Do not allow fans to blow directly into the fireplace. 

Avoid any drafts that alter burner flame patterns.

wArNING: 

Do not use a blower insert, heat exchanger insert or 

other accessory not approved for use with this heater.

candles

Avoid the use of scented or decorative candles while the log set is in 

operation. Candles produce a residue in the air that creates a soot like 

substance. Burning candles while the log set is operating magnifies 

the problem. It should be noted that candles, in general, produce 

soot. The amount of time burned and the quantity of candles burned 

will determine the amount of soot produced and deposited.

Make Owners Aware of Proper Log Set Operation

Properly installed and properly maintained log sets do not deposit 

soot on the logs. If users see soot appear on a log, call for service. 

Do not continue to operate the log set.

Qualified Installing Agency

Installation and replacement of gas piping, gas utilization equip

-

ment or accessories and repair and servicing of equipment shall be 

performed only by a qualified agency. The term "qualified agency" 

means any individual, firm, corporation, or company that either in 

person or through a representative is engaged in and is responsible 

for (a) the installation, testing, or replacement of gas piping or (b) the 

connection, installation, testing, repair, or servicing of equipment; 

that is experienced in such work; that is familiar with all precau

-

tions required, and that has complied with all the requirements of 

the authority having jurisdiction.

The installation must conform with local codes or, in the absence 

of local codes, with the National Fuel Gas Code, ANSI Z223.1/

NFPA54* or International Fuel Gas Code.

*Available from the American National Standards Institute, Inc. 11 West 42nd 

St., New York, N.Y. 10018.

State of Massachusetts: The installation must be made by a 

licensed plumber or gas fitter in the Commonwealth of Mas

-

sachusetts.

Sellers of unvented propane or natural gas-fired supplemental 

room heaters shall provide to each purchaser a copy of 527 CMR 
30 upon sale of the unit.

In the State of Massachusetts, unvented propane and natu

-

ral gas-fired space heaters shall be prohibited in bedrooms 

and bathrooms.

IMPORTANT INSTALLATION GUIDELINES

GENERAL INFORMATION

Summary of Contents for LSU24RR-2









Reviews: